OPERATION DESCRIPTION

End covers are installed on a cylinder head (or cylinder block), with an air blowpipe on one of them. CH (CB) is installed on a turning table (platform). Cooling jacket holes are sealed with rubber gaskets and then covered with a thick plexiglass sheet. When the parts are clamped on the table, compressed air is supplied. The part is dipped into a bath and stays there for 15 to 20 minutes until specified temperature is achieved. The defect area is defined visually according to the air leakage. The part can be rotated 360 ° inside the bath for testing convenience^о.

DISTINCTIVE FEATURES

• Increased supporting power of platform containing the work piece;
• extended (up to 90 °C) ^оС) range of engine thermal stress modelling;
• possibility of testing parts with the length of not more than 130 mm;
• independent start of 3 electric THEs;
• water-driven lifting mechanism for simple operation with heavy parts;
• electro-mechanical drive provides for 360 ° table rotation^о for quick defect detection;
• three pull-out drawers for storing tools and equipment.